Toyota Venza manuals

Toyota Venza: Door Lock

Installation
INSTALLATION PROCEDURE 1. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY (a) Engage the claw to install the windshield wiper switch assembly as shown in the illustration. ...

Back Door Lock
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE BACK DOOR PANEL TRIM ASSEMBLY 2. REMOVE BACK DOOR LOCK ASSEMBLY (a) Disconnect the connector. ...

Other materials about Toyota Venza:

ECU Power Source Circuit
DESCRIPTION When the ignition switch is turned to ON, voltage from the ECM's MREL terminal is applied to the EFI MAIN relay. This causes the contacts of the EFI MAIN relay to close, which supplies power to terminal +B of the TCM. WIRING DIAGRAM PR ...

Inspection
INSPECTION PROCEDURE 1. INSPECT INTAKE AIR CONTROL VALVE (for ACIS) (a) Inspect the diaphragm. (1) Using a vacuum pump, apply a vacuum of 60 kPa (450 mmHg, 17.7 in.Hg) or higher to the diaphragm chamber. Wait for 1 minute and check that the ...

Headlight Signal Circuit
DESCRIPTION The headlight leveling ECU assembly detects the low beam headlights status. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: First check that the low beam headlights operate normally. PROCEDURE 1. CHECK HARNESS AND CON ...

© 2016-2026 Copyright www.tovenza.com

0.1329