Toyota Venza: Precaution

Toyota Venza Service Manual / Door Lock / Wireless Door Lock Control System(w/o Smart Key System) / Precaution

PRECAUTION

1. PRECAUTION FOR DISCONNECTING THE BATTERY CABLE

NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the terminal is reconnected.

System Name	See Procedure
Back Door Closer System
Power Back Door System

2. PRECAUTION WHEN USING TECHSTREAM

(a) When using the Techstream to troubleshoot the power door lock control system:

Connect the Techstream to the DLC3 while the ignition switch is off, and turn a door courtesy light switch on and off at 1.5-second intervals until communication between the Techstream and vehicle begins.

Wireless Door Lock Control System(w/o Smart Key System)

...

Parts Location

PARTS LOCATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repair" after replacing the engine assembly (See page ). PROCEDURE 1. INSTALL IGNITION COIL ASSEMBLY 2. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY 3. INSTALL ENGINE COOL ...

Open in Rear Floor Electrical Key Oscillator Circuit (B27A6)
DESCRIPTION The certification ECU (smart key ECU assembly) generates a request signal and sends it to the indoor electrical key oscillator (for center floor). To detect the key inside the cabin, the indoor electrical key oscillator (for center floor) crea ...

Short in Driver Side Knee Airbag Squib Circuit (B1860/64-B1863/64)
DESCRIPTION The driver side knee airbag squib circuit consists of the center airbag sensor assembly and driver side knee airbag assembly. The center airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These ...