Toyota Venza: Installation

Toyota Venza Service Manual / Door Lock / Door Control Receiver / Installation

INSTALLATION

PROCEDURE

1. INSTALL DOOR CONTROL RECEIVER

(a) Install the door control receiver with the bolt.

(b) Connect the connector.

2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH

HINT:

Use the same procedure for the RH side and LH side (See page ).

3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH

4. CONNECT REAR SEAT OUTER BELT ASSEMBLY

HINT:

Use the same procedure for the RH side and LH side (See page ).

5. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY

HINT:

Use the same procedure for the RH side and LH side (See page ).

6. INSTALL RECLINING REMOTE CONTROL BEZEL

HINT:

Use the same procedure for the RH side and LH side (See page ).

7. INSTALL REAR SEAT ASSEMBLY RH

8. CONNECT REAR SEAT RECLINING CONTROL CABLE SUB-ASSEMBLY

9. INSTALL REAR SEAT OUTER TRACK BRACKET COVER RH

10. INSTALL REAR SEAT INNER TRACK BRACKET COVER RH

11. INSTALL REAR SEAT CENTER HEADREST ASSEMBLY

12. INSTALL REAR SEAT HEADREST ASSEMBLY RH

13. INSTALL REAR FLOOR FINISH PLATE

14. INSTALL REAR SEAT SUB FLOOR PANEL ASSEMBLY

15. INSTALL NO. 1 DECK BOARD

16. INSTALL DECK SIDE TRIM BOX LH

17. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY

18. INSTALL DECK SIDE TRIM BOX RH

19. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY

20. INSTALL DECK BOARD ASSEMBLY

21. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

22. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH

23. INSTALL REAR DOOR SCUFF PLATE RH

HINT:

Use the same procedure for the RH side and LH side (See page ).

Removal

REMOVAL PROCEDURE 1. REMOVE REAR DOOR SCUFF PLATE RH HINT: Use the same procedure for the RH side and LH side (See page ). 2. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH HINT: Use the s ...

Door Control Switch

Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT DOOR CONTROL SWITCH ASSEMBLY (a) Measure the resistance according to the value(s) in the table bel ...

Other materials about Toyota Venza:

Power Window Switch Malfunction (B2312)
DESCRIPTION The power window regulator motor assembly is operated by the power window regulator master switch assembly or power window regulator switch assembly. The power window regulator motor assembly has motor, regulator and ECU functions. This DTC i ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. DTC CHECK/CLEAR (When Using the Techstream) (a) Check for DTCs. (1) Connect the Techstream to the DLC3. (2) Turn the ignition switch to ON. (3) Turn the Techstream on. (4) Read the DTCs following the prompts on the Techstream. Enter ...

Hill-start assist control
Hill-start assist control helps to prevent the vehicle from rolling backwards when starting on incline or slippery slope. To engage hill-start assist control, further depress the brake pedal when the vehicle is stopped completely. A buzzer will sound o ...