Toyota Venza: Front Door Lock

Door Control Transmitter(w/o Smart Key System)

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE TRANSMITTER HOUSING COVER 2. REMOVE DOOR CONTROL TRANSMITTER MODULE Inspection INSPECTION PROCEDURE 1. I ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Inspection
INSPECTION PROCEDURE 1. INSPECT NO. 1 ULTRASONIC SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified ...

Check CAN Bus Line for Short to GND
DESCRIPTION There may be a short circuit between the CAN bus main wire and GND when there is no resistance between terminals 6 (CANH) and 4 (CG) or 14 (CANL) and 4 (CG) of the DLC3. Symptom Trouble Area No resistanc ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repair" after replacing the camshaft, No. 2 camshaft, camshaft timing gear assembly, camshaft timing exhaust gear assembly or cylinder head sub-assembly (See page ). PROCED ...