Toyota Venza manuals

Toyota Venza: Diagnosis System

DIAGNOSIS SYSTEM

1. CHECK DLC3

(a) Check the DLC3 (See page ).


2. INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery.

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY) (a) Disconnect the 2C, 2F and 2K main body ECU (driver side junction block assembly) connectors. (b) Measure the vo ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Other materials about Toyota Venza:

Open or Short Circuit in ABS Solenoid Relay Circuit (C0278/11)
DESCRIPTION The ABS solenoid relay supplies power to the ABS solenoid and TRAC solenoid. The solenoid relay is turned on 1.5 seconds after the ignition switch is turned to ON, and is turned off if an open or short in the solenoid is detected by self diag ...

Portable Player cannot be Registered
CAUTION / NOTICE / HINT HINT: Some versions of "Bluetooth" compatible audio players may not function properly, or the functions may be limited using the radio and display receiver assembly, even if the portable audio player itself can play file ...

Installation
INSTALLATION PROCEDURE 1. INSTALL HEADLIGHT ASSEMBLY (a) Connect each connector. (b) Install the headlight assembly with the bolt and 3 screws. Torque: 3.6 N·m {37 kgf·cm, 32 in·lbf} 2. INSTALL FRONT BUMPER ASSEMBLY (See page ) 3. CONNECT CABLE T ...

© 2016-2026 Copyright www.tovenza.com

0.1578