Toyota Venza: Power Door Lock Control System
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Data List / Active Test
- All Doors LOCK/UNLOCK Functions do not Operate Via Door Control Switch
Key Reminder Buzzer does not Sound
DESCRIPTION
The key reminder warning buzzer sounds when the driver side door is opened while
the ignition switch is in LOCK or ACC. The key reminder warning buzzer is activated
when the main body ...
Precaution
PRECAUTION
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following systems after the cable is reconnected.
System Name
See Proc ...
Other materials about Toyota Venza:
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Perform "Inspection After Repair" after replacing the engine assembly (See page
).
PROCEDURE
1. INSTALL IGNITION COIL ASSEMBLY
2. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY
3. INSTALL ENGINE COOL ...
Actuator Supply Voltage Circuit / Open (P0657)
MONITOR DESCRIPTION
The ECM monitors the output voltage to the throttle actuator. This self-check
ensures that the ECM is functioning properly. The output voltage is usually 0 V
when the ignition switch is turned off. If the output voltage is higher than ...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NO. 2 STEERING RACK BOOT
(a) Apply lithium soap base glycol grease to the inside of the small
opening of a new No. 2 steering rack boot.
(b) Install the No. 2 ste ...
0.1834