Toyota Venza: Lighting System
- Parts Location
- Precaution
- System Description
- System Diagram
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Initialization
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Fail-safe Chart
- Freeze Frame Data
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Vehicle Specifications have not been Stored (B2451)
- Lost Communication with Automatic High Beam Sensor (B2432)
- Initialization has not been Performed (B2450)
- HL AutoLeveling ECU Failure (B2420)
- Rear Height Control Sensor (B241A)
- Height Control Sensor Malfunction (B2416)
- Vehicle Speed Sensor Malfunction (B2415)
- Height Control Sensor Data Out of Range When Initializing (B2452)
- Variation Error (B2453)
- Light Sensor Circuit Malfunction (B1244)
- Lost Communication with ECM (U0101,U0073,U0126,U0129,U0142,U0182,U1000)
- Automatic High Beam Mirror (B124A)
- Automatic High Beam System (B124B)
- Automatic High Beam Camera (B124C)
- Lost Communication with AFS LIN (B124D)
- Steering Position Sensor Malfunction (B2414)
- Headlight Relay Circuit
- Headlight Solenoid Circuit
- Daytime Running Light Relay Circuit
- Headlight (HI-BEAM) Circuit
- Front Fog Light Circuit
- Headlight Signal Circuit
- Light Control Switch Circuit
- Door Mirror Foot Light Circuit
- Parking Brake Switch Circuit
- Taillight Relay Circuit
- Headlight Beam Level Control Actuator Circuit
- Headlight Leveling ECU Power Source Circuit
- Indicator Circuit
- Speed Signal Circuit
- Inner Rear View Mirror Power Source Circuit
- LVL Terminal Circuit
- Diagnosis Circuit
License Plate Light Assembly
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL LICENSE PLATE LIGHT ASSEMBLY
(a) Engage the 2 claws to install the license pla ...
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...
Other materials about Toyota Venza:
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT DRIVER SIDE SEAT BELT WARNING
(a) Turn the ignition switch to ON.
(b) When the driver side seat belt is not fastened, check that the driver side
seat belt warning light on the combination meter assembly blinks.
...
ABS Warning Light Remains ON
DESCRIPTION
The skid control ECU is connected to the combination meter via CAN communication.
If any of the following is detected, the ABS warning light remains on:
The skid control ECU connector is disconnected from the skid control
ECU.
The ...
VIN not Programmed or Mismatch - ECM / PCM (P0630)
MONITOR DESCRIPTION
DTC P0630 is stored when the Vehicle Identification Number (VIN) is not stored
in the Engine Control Module (ECM) or the input VIN is not accurate. Input the VIN
with the Techstream.
DTC No.
DTC Detection Conditi ...
0.1365