Toyota Venza: Automatic High Beam Camera (B124C)

Toyota Venza Service Manual / Lighting (ext) / Lighting System / Automatic High Beam Camera (B124C)

DESCRIPTION

The DTC is stored when the main body ECU (driver side junction block assembly) detects malfunctions in the camera (inner rear view mirror assembly).

DTC No.	DTC Detection Condition	Trouble Area
B124C	Malfunction in camera (inner rear view mirror assembly)	Inner rear view mirror assembly

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this symptom.

PROCEDURE

1.	CHECK FOR DTC

(a) Clear the DTCs (See page ).

(b) Check for DTCs (See page ).

OK:

DTC B124C is not output.

USE SIMULATION METHOD TO CHECK

REPLACE INNER REAR VIEW MIRROR ASSEMBLY

Automatic High Beam System (B124B)

DESCRIPTION The DTC is stored when the main body ECU (driver side junction block assembly) detects malfunctions in the automatic high beam system. DTC No. DTC Detection Condi ...

Lost Communication with AFS LIN (B124D)

DESCRIPTION The DTC is stored when the main body ECU (driver side junction block assembly) detects malfunctions in the LIN communication system. DTC No. DTC Detection Conditi ...

Other materials about Toyota Venza:

Low Power Supply Voltage (C1241/94)
DESCRIPTION If a malfunction in the power source circuit occurs, or a malfunction in communication with the skid control ECU or in a speed sensor occurs, the AWD control ECU will prohibit operations by the fail-safe function. DTC No. ...

Lost Communication with ECM / PCM (U0100)
DESCRIPTION DTC No. DTC Detection Condition Trouble Area U0100 No communication from the ECM continues. ECM main wire or connector Power source circuit of ECM ECM ...

Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter
DESCRIPTION The stereo component amplifier assembly receives a vehicle speed signal from the combination meter assembly to control the ASL function. HINT: A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter ...