Toyota Venza: Vehicle Specifications have not been Stored (B2451)

Toyota Venza Service Manual / Lighting (ext) / Lighting System / Vehicle Specifications have not been Stored (B2451)

DESCRIPTION

The headlight leveling ECU assembly stores this DTC if the vehicle specifications have not been stored in the ECU.

HINT:

The vehicle specifications are stored in the ECU at the factory.

DTC No.	DTC Detecting Condition	Trouble Area
B2451	Vehicle specifications have not been stored	Headlight leveling ECU assembly

PROCEDURE

1.	REPLACE HEADLIGHT LEVELING ECU ASSEMBLY

(a) Replace the headlight leveling ECU assembly (See page ).

2.	PERFORM INITIALIZATION

(a) Perform initialization of the headlight leveling ECU assembly (See page ).

END

Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART Lighting System DTC Code Detection Item See page B1244 Light Sensor Circuit Malfunction ...

Lost Communication with Automatic High Beam Sensor (B2432)

DESCRIPTION The DTC is stored when the AFS ECU (headlight swivel ECU assembly) detects malfunctions in the LIN communication system. DTC No. DTC Detection Condition ...

Other materials about Toyota Venza:

Voice Guidance does not Function
PROCEDURE 1. CHECK VOICE GUIDANCE SETTING (a) Check that the voice guidance setting is not off. OK: Voice guidance setting is not off. NG CHANGE THE VOICE GUIDANCE SETTING TO ON ...

Installation
INSTALLATION PROCEDURE 1. INSTALL FRONT SEAT ASSEMBLY (a) Place the front seat assembly in the cabin. NOTICE: Be careful not to damage the vehicle body. (b) Connect each connector under the front seat assembly. (c) Connect the cable to the negative (-) ...

Stop Light Control Relay Malfunction (C1380/64)
DESCRIPTION Upon receiving the hill-start assist control operating signal from the skid control ECU, the relay contact turns on and the stop light comes on. DTC Code DTC Detection Condition Trouble Area C13 ...