Toyota Venza: Initialization has not been Performed (B2450)

Toyota Venza Service Manual / Lighting (ext) / Lighting System / Initialization has not been Performed (B2450)

DESCRIPTION

The headlight leveling ECU assembly stores this DTC if initialization has not been performed after the ECU was replaced.

DTC No.	DTC Detecting Condition	Trouble Area
B2450	Initialization of the headlight leveling ECU assembly has not been performed	Headlight leveling ECU assembly

PROCEDURE

1.	PERFORM INITIALIZATION

(a) Perform initialization of the headlight leveling ECU assembly (See page ).

2.	RECHECK FOR DTC

(a) Using the Techstream, recheck for DTCs.

Result	Proceed to
DTC B2450 is not output.	A
DTC B2450 is output.	B

HINT:

If the headlight leveling ECU assembly stores DTC B2450 even though the ECU has been initialized, there may be a malfunction in the headlight leveling ECU assembly.

END

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY

Lost Communication with Automatic High Beam Sensor (B2432)

DESCRIPTION The DTC is stored when the AFS ECU (headlight swivel ECU assembly) detects malfunctions in the LIN communication system. DTC No. DTC Detection Condition ...

HL AutoLeveling ECU Failure (B2420)

DESCRIPTION When the headlight leveling ECU assembly detects a malfunction in itself, this DTC is stored. DTC No. DTC Detecting Condition Trouble Area ...

Other materials about Toyota Venza:

Cleaning and protecting the vehicle interior
The following procedures will help protect your vehicle’s interior and keep it in top condition: - Protecting the vehicle interior Remove dirt and dust using a vacuum cleaner. Wipe dirty surfaces with a cloth dampened with lukewarm water. - Cleaning t ...

Driver Side Seat Belt Warning Light does not Operate
DESCRIPTION When the ignition switch is ON, the center airbag sensor assembly transmits front seat inner belt status signals to the combination meter assembly through CAN. If the driver seat belt is not fastened, the combination meter assembly blinks the ...

Installation
INSTALLATION PROCEDURE 1. INSTALL SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY (a) Install the spiral with sensor cable sub-assembly (See page ). NOTICE: Do not replace the spiral cable with the battery connected and the engine switch on (IG). ...