Toyota Venza: Power Steering System
- Parts Location
- Precaution
- System Diagram
- How To Proceed With Troubleshooting
- System Description
- Calibration
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Freeze Frame Data
- Data List / Active Test
- Fail-safe Chart
- Diagnostic Trouble Code Chart
- On-vehicle Inspection
- Lost Communication with ECM / PCM "A" (U0100,U0129)
- Assist Map Number Mismatch (C1582)
- PIG Power Supply Voltage Malfunction (C1552)
- Assist Map Number Un-Writing (C1581)
- IG Power Supply Voltage Malfunction (C1551)
- Motor Rotation Angle Sensor Malfunction (C1528)
- Vehicle Speed Signal Malfunction (C1541)
- Motor Circuit Malfunction (C1522-C1555)
- Torque Sensor Zero Point Adjustment Incomplete (C1516,C1526)
- Motor Circuit Malfunction (C1521,C1531-C1534,C1554)
- Torque Sensor Circuit Malfunction (C1511-C1514,C1517)
- Torque Sensor Zero Point Adjustment Undone (C1515,C1525)
- PS Warning Light Remains ON
Installation
INSTALLATION
PROCEDURE
1. INSTALL POWER STEERING ECU ASSEMBLY
(a) Engage the 4 wire harness clamps to the power steering ECU assembly.
...
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
...
Other materials about Toyota Venza:
Disassembly
DISASSEMBLY
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting
the cable from the negative (-) battery terminal. Therefore, make sure to read the
disconnecting the cable from the neg ...
Dtc Check / Clear
DTC CHECK / CLEAR
NOTICE:
When the diagnosis system is changed from normal mode to check mode or vice versa,
all DTCs and freeze frame data recorded in normal mode are cleared. Before changing
modes, always check and make a note of DTCs and freeze frame ...
Removal
REMOVAL
PROCEDURE
1. REMOVE AIR CONDITIONING UNIT ASSEMBLY
(See page )
2. REMOVE NO. 1 FINISH PANEL MOUNTING BRACKET
3. REMOVE NO. 2 FINISH PANEL MOUNTING BRACKET
4. REMOVE NO. 3 AIR DUCT SUB-ASSEMBLY
5. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY
...
0.1283