Toyota Venza: Front Suspension
- Front Lower Ball Joint
- Front Lower Suspension Arm(when Not Using The Engine Support Bridge)
- Front Lower Suspension Arm(when Using The Engine Support Bridge)
- Front Shock Absorber
- Front Stabilizer Bar(when Not Using The Engine Support Bridge For Awd)
- Front Stabilizer Bar(when Using The Engine Support Bridge For Awd)
- Front Stabilizer Bar(for 1ar-fe 2wd)
- Front Stabilizer Bar(for 2gr-fe 2wd)
- Front Suspension Member(when Not Using The Engine Support Bridge)
- Front Suspension Member(when Using The Engine Support Bridge For 1ar-fe)
- Front Suspension Member(when Using The Engine Support Bridge For 2gr-fe)
- Front Suspension System
Rear Wheel Alignment
Adjustment
ADJUSTMENT
PROCEDURE
1. INSPECT TIRES
(a) Inspect the tires (See page ).
2. MEASURE VEHICLE HEIGHT
3. INSPECT CAMBER
Camber (Unloaded Vehicle):
Model
En ...
Other materials about Toyota Venza:
Door Courtesy Switch Circuit
DESCRIPTION
The main body ECU (driver side junction block assembly) detects the condition
of the door courtesy light switch.
WIRING DIAGRAM
PROCEDURE
1.
READ VALUE USING TECHSTREAM
(a) Connect the Techstream to the DLC3 ...
Precaution
PRECAUTION
1. EXPRESSIONS OF IGNITION SWITCH
(a) The type of ignition switch used on this model differs according to the specifications
of the vehicle. The expressions listed in the table below are used in this section.
Switch Type
I ...
Rear Light Assembly
Components
COMPONENTS
ILLUSTRATION
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT REAR LIGHT ASSEMBLY
(a) Disconnect the connector from the rear light assembly.
(b) Measu ...
0.1615