Toyota Venza: Front Suspension Member(when Not Using The Engine Support Bridge)

Front Stabilizer Bar(for 2gr-fe 2wd)

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE FRONT FRAME ASSEMBLY (When Using the Engine Support Bridge) (See page ) 2. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE ( ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. REMOVE NO. 1 SLIDING ROOF GLASS SUB-ASSEMBLY (a) Fully open the No. 2 sliding roof glass sub-assembly. (b) Using a T20 "TORX" socket wrench, remove the 6 screws and No. 1 sliding roof glass sub-assembly. ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. SECURE REAR SHOCK ABSORBER WITH COIL SPRING 2. INSTALL REAR LOWER COIL SPRING ...

Engine Control System Malfunction (C1201/51)
DESCRIPTION If a malfunction in the engine control system is detected, the operations of VSC and TRAC are prohibited by the fail-safe function. When the signals from the engine are input normally, the fail-safe is cancelled and the DTC is not stored. ...