Toyota Venza: Front Stabilizer Bar(when Using The Engine Support Bridge For Awd)

Front Stabilizer Bar(when Not Using The Engine Support Bridge For Awd)

Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT FRONT STABILIZER LINK ASSEMBLY (a) Inspect the turning torque of the ball joint. (1) Secure the ...

Components

COMPONENTS ILLUSTRATION ...

Other materials about Toyota Venza:

Inspection
INSPECTION PROCEDURE 1. INSPECT UNIVERSAL JOINT SPIDER ASSEMBLY (a) Check the spider bearing axial play by turning the flange while holding the shaft tightly. HINT: If necessary, replace the propeller with center bearing shaft assembly. ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART CAN Communication System DTC Code Detection Item Output ECU/Techstream Display See page U0100 Lost Communication with ECM / PCM Power management ...

Installation
INSTALLATION PROCEDURE 1. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG (a) Temporarily tighten the front disc brake bleeder plug. HINT: Fully tighten the front disc brake bleeder plug after bleeding any air left in the system. (b) Install the fron ...