Toyota Venza: Front Lower Ball Joint

Front Suspension

Components

Other materials about Toyota Venza:

Disposal
DISPOSAL PROCEDURE 1. DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY (a) Position the front shock absorber assembly level with the piston rod fully extended. Using a drill, make a hole in the cylinder between A and B as shown in the illustratio ...

Installation
INSTALLATION PROCEDURE 1. INSTALL HEATED OXYGEN SENSOR 2. INSTALL FRONT EXHAUST PIPE ASSEMBLY (a) Using a vernier caliper, measure the free length of the compression springs. Minimum Free Length: 41.5 mm (1.63 in.) If the free l ...

Performance Decline of Brake Function (C1441)
DESCRIPTION The skid control ECU judges brake failure conditions have occurred based on the signal from the brake pedal load sensing switch and master cylinder pressure sensor. NOTICE: Do not intentionally stop the engine when driving. Even when no malfun ...