Toyota Venza manuals

Toyota Venza: 1ar-fe Cooling

Toyota Venza Service Manual / 1ar-fe Cooling

Installation
INSTALLATION PROCEDURE 1. INSTALL MANUAL VALVE (a) Coat the manual valve with ATF and install it to the transmission valve body assembly. 2. SUPPORT ENGINE ASSEMBLY 3. INSTALL TRANSMISSION V ...

Coolant
Replacement REPLACEMENT PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER 2. REMOVE NO. 2 ENGINE UNDER COVER 3. DRAIN ENGINE COOLANT (a) Loosen the radiator drain cock plug and drain the coolant. ...

Other materials about Toyota Venza:

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART If a trouble code is displayed during the DTC check, check the parts listed for that code in the table below and proceed to the appropriate page. HINT: The steering lock ECU does not store DTCs regarding the past problems. S ...

Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 2 WINDSHIELD GLASS STOPPER (a) Using a brush or a sponge, coat the application area of 2 new No. 2 windshield glass stoppers with Primer G. NOTICE: Do not apply too much primer. Allow the primer to dry f ...

Intermediate Shaft Speed Sensor "A" Circuit (P0791,P0793)
DESCRIPTION This sensor detects the rotation speed of the counter gear which shows the output speed of transaxle. By comparing the input turbine speed signal (NT) with the counter gear speed sensor signal (NC), the TCM detects the shift timing of the gear ...

© 2016-2026 Copyright www.tovenza.com

0.1605