Toyota Venza manuals

Toyota Venza: Cooling Fan System

Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 2 COOLING FAN MOTOR (a) Install the No. 2 cooling fan motor with the 3 screws. Torque: w/o Towing package : 2.6 N·m {26 kgf·cm, 23 in· ...

Precaution
PRECAUTION NOTICE: When the ignition switch is turned off and the engine temperature is high, the cooling fans may operate for a maximum of 6 minutes. After turning the ignition swit ...

Other materials about Toyota Venza:

Ignition Hold Monitor Malfunction (B2271)
DESCRIPTION This DTC is stored when a problem such as an open in the AM2 fuse, an open or short in the wire harness between the fuse and power management control ECU, a short in the IG output circuit inside the power management control ECU, a short betwee ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" ...

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT DISCHARGE HEADLIGHT BULB NOTICE: Confirm the following items before replacing a discharge headlight bulb. If a malfunction is discovered and repaired, perform the inspection again to confirm the repair. ...

© 2016-2026 Copyright www.tovenza.com

0.1576