Toyota Venza: Installation

Toyota Venza Service Manual / 1ar-fe Cooling / Water Pump / Installation

INSTALLATION

PROCEDURE

1. INSTALL WATER PUMP ASSEMBLY

(a) Install a new gasket and the water pump with the 7 bolts.

Torque:

21 N·m {214 kgf·cm, 15 ft·lbf}

2. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY

3. INSTALL GENERATOR ASSEMBLY

4. INSTALL WIRE HARNESS CLAMP BRACKET

5. INSTALL V-RIBBED BELT

HINT:

See page

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

7. ADD ENGINE COOLANT

8. INSPECT FOR COOLANT LEAK

9. INSTALL COOL AIR INTAKE DUCT SEAL

10. INSTALL NO. 1 ENGINE UNDER COVER

11. INSTALL NO. 2 ENGINE UNDER COVER

12. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Removal

REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. RE ...

Other materials about Toyota Venza:

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (a) Apply a total of 0.1 to 0.3g (0.00 ...

Components
COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful bec ...

Toyota Venza: Installation

Removal

1ar-fe Emission Control

Other materials about Toyota Venza: