Toyota Venza: Drive Shaft / Propeller Shaft

Steering Knuckle

Components COMPONENTS ILLUSTRATION Removal REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH s ...

Drive Shaft System

Precaution PRECAUTION 1. NOTICE OF REMOVING AND INSTALLING FRONT DRIVE SHAFT ASSEMBLY RH (a) When removing and installing the front drive shaft assembly RH in a AWD vehicle, be sure to first dr ...

Other materials about Toyota Venza:

Road Test
ROAD TEST 1. PROBLEM SYMPTOM CONFIRMATION (a) Based on the result of the customer problem analysis, try to reproduce the symptoms. If the problem is that the transaxle does not shift up, shift down, or the shift point is too high or too low, conduct the ...

Relay
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT IG2 RELAY (a) Remove the IG2 relay from the relay block. (b) Measure the resistance according to the value(s) in the table below. Standard Resistance: Te ...

Crankshaft Position Sensor
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE FRONT FENDER APRON SEAL RH 2. REMOVE CRANKSHAFT POSITION SENSOR (a) Disconnect the sensor connector. (b) Remove the bolt and sensor. Inspection INSPECTION PROCEDURE ...