Toyota Venza: Rear Drive Shaft Assembly(for Awd)

Propeller Shaft System

Problem Symptoms Table PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symp ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Initialization
INITIALIZATION 1. RESET BACK DOOR CLOSE POSITION (w/ POWER BACK DOOR SYSTEM) NOTICE: Perform initialization of the power back door system (power back door ECU initialization) if one of the following is performed: The cable is disconnected from the ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH side and RH side. The following procedure is for the LH side. If the sensor rotor needs to be replaced, replace it together with the rear drive shaft assembly. ...

Relay
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. FAN NO. 1 RELAY (a) Remove the relay from the engine room relay block. (b) Measure the resistance according to the value(s) in the table b ...