Toyota Venza: Sliding Roof / Convertible
- Sliding Roof Housing
- Sliding Roof Switch Assembly
- Sliding Roof System
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Operation Check
- Initialization
- Problem Symptoms Table
- Diagnosis System
- Terminals Of Ecu
- Data List / Active Test
- Dtc Check / Clear
- Position Initialization Incomplete (B2343)
- Diagnostic Trouble Code Chart
- Switch Failure (B2342)
- Sensor (Motor) Failure (B2341,B2344)
- Sliding Roof does not Move by Operating Sliding Roof Control Switch
Power Mirror Control System(w/o Memory)
Parts Location
PARTS LOCATION
ILLUSTRATION
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple
suspected ...
Other materials about Toyota Venza:
Precaution
PRECAUTION
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following systems after the cable is reconnected.
System Name
See Procedure
Back Door Closer System
...
Customizing the features by using the multi-information display (vehicles with
TFT type multi-information display)
Press the “SETUP” button while the vehicle is stopped.
The “Custom Settings” screen is displayed on the multi-information display.
If left idle for approximately 10 seconds, the display will revert to the previous
screen.
Select the setting yo ...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)
(a) Disconnect the 2F and 2C driver side junction block connectors.
(b) Disconnect the D50 and D51 main body ECU connectors.
(c) Measure the resistance and voltage according to ...
0.1408