Toyota Venza: Diagnostic Trouble Code Chart

Toyota Venza Service Manual / Sliding Roof / Convertible / Sliding Roof System / Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART

Sliding Roof (Sliding Roof ECU (Sliding Roof Drive Gear Sub-assembly))

DTC Code	Detection Item	Trouble Area
B2341	Sensor (Motor) Failure	1. Sliding roof ECU (Sliding roof drive gear sub-assembly) 2. Sliding roof switch (Roof console box assembly) 3. Wire harness or connector
B2342	Switch Failure	1. Sliding roof ECU (Sliding roof drive gear sub-assembly) 2. Sliding roof switch (Roof console box assembly) 3. Wire harness or connector
B2343	Position Initialization Incomplete	Sliding roof ECU (Sliding roof drive gear sub-assembly)
B2344	Position Failure	1. Sliding roof ECU (Sliding roof drive gear sub-assembly) 2. Sliding roof switch (Roof console box assembly) 3. Wire harness or connector

Position Initialization Incomplete (B2343)

DESCRIPTION This DTC is output when the sliding roof ECU (sliding roof drive gear sub-assembly) has not been initialized. DTC Code DTC Detection Condition Trouble ...

Switch Failure (B2342)

DESCRIPTION This DTC is output when the sliding roof ECU (sliding roof drive gear sub-assembly) detects that the sliding roof switch is stuck for 30 seconds or more. DTC Code ...

Other materials about Toyota Venza:

Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE: If automatic transaxle assembly parts are replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary (See page ). PROCEDURE 1. REMOVE ENGINE ASSEMBLY WITH TR ...

Antenna location and effective range
- Antenna location 1. Antennas outside cabin 2. Antennas inside cabin 3. Antenna outside luggage compartment - Effective range (areas within which the electronic key is detected) When locking or unlocking the doors The system can be operat ...

Precaution
PRECAUTION 1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected. System Name ...