Toyota Venza manuals

Toyota Venza: Dtc Check / Clear

DTC CHECK / CLEAR

1. CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Sliding Roof / Trouble Codes.

(e) Check the details of the DTC(s) (See page ).


2. CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Sliding Roof / Trouble Codes.

(e) Clear the DTC(s).

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Position Initialization Incomplete (B2343)
DESCRIPTION This DTC is output when the sliding roof ECU (sliding roof drive gear sub-assembly) has not been initialized. DTC Code DTC Detection Condition Trouble ...

Other materials about Toyota Venza:

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repair" after replacing the fuel pump assembly (See page ). PROCEDURE 1. DISCHARGE FUEL SYSTEM PRESSURE (a) Discharge fuel system pressure (See page ). 2. DISCONNECT CABLE FR ...

Actuator Supply Voltage Circuit / Open (P0657)
MONITOR DESCRIPTION The ECM monitors the output voltage to the throttle actuator. This self-check ensures that the ECM is functioning properly. The output voltage is usually 0 V when the ignition switch is turned off. If the output voltage is higher than ...

Antenna location and effective range
 - Antenna location 1. Antennas outside cabin 2. Antennas inside cabin 3. Antenna outside luggage compartment  - Effective range (areas within which the electronic key is detected) When locking or unlocking the doors The system can be operat ...

© 2016-2026 Copyright www.tovenza.com

0.1493