Toyota Venza: Occupant Classification System
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- System Description
- Initialization
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Fail-safe Chart
- Sleep Operation Failure of Occupant Classification ECU (B1796)
- Diagnostic Trouble Code Chart
- Occupant Classification ECU Malfunction (B1795)
- Occupant Classification Sensor Power Supply Circuit Malfunction (B1793)
- Open in Occupant Classification ECU Battery Positive Line (B1794)
- Center Airbag Sensor Assembly Communication Circuit Malfunction (B1790)
- Rear Occupant Classification Sensor LH Collision Detection (B1787)
- Rear Occupant Classification Sensor RH Collision Detection (B1788)
- Front Occupant Classification Sensor RH Collision Detection (B1786)
- Front Occupant Classification Sensor LH Collision Detection (B1785)
- Rear Occupant Classification Sensor LH Circuit Malfunction (B1782)
- Rear Occupant Classification Sensor RH Circuit Malfunction (B1783)
- Front Occupant Classification Sensor RH Circuit Malfunction (B1781)
- Passenger Side Buckle Switch Circuit Malfunction (B1771)
- Front Occupant Classification Sensor LH Circuit Malfunction (B1780)
- Trouble in Passenger Airbag ON/OFF Indicator
Occupant Classification Ecu
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to follow the correct removal and installation proc ...
Precaution
PRECAUTION
1. PRECAUTION FOR DISCONNECTING THE BATTERY CABLE
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following systems after the cable is recon ...
Other materials about Toyota Venza:
CD cannot be Inserted or is Ejected Right After Insertion
PROCEDURE
1.
CHECK IF A PROPER CD IS INSERTED
(a) Make sure that the CD is an audio CD or a CD with an MP3, WMA or AAC files,
and that it is not deformed, flawed, stained, deteriorated or otherwise defective.
OK:
Normal C ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)
(a) Install the vacuum switching valve assembly (for ACIS) with the bolt.
Torque:
9.0 N·m {92 kgf·cm, 80 in·lbf}
...
Installation
INSTALLATION
PROCEDURE
1. INSTALL STUD BOLT (for LH Side)
(a) Install the stud bolt.
Torque:
17 N·m {173 kgf·cm, 13 ft·lbf}
2. INSTALL STUD BOLT (for RH Side)
HINT:
Perform the same proc ...
0.1571