Toyota Venza: Installation

Toyota Venza Service Manual / Window / Glass / Power Window Regulator Motor(for Front Door) / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY

NOTICE:

The regulator arm must be below the intermediate position when installing the front power window regulator motor assembly.

(a) Using a T25 "TORX" driver, install the front power window regulator motor assembly with the 3 screws.

Torque:

5.4 N·m {55 kgf·cm, 48 in·lbf}

HINT:

A new front window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

2. INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY

3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

4. INSTALL FRONT DOOR SERVICE HOLE COVER

5. INSTALL DOOR SIDE AIRBAG SENSOR

6. INSTALL FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY

7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

8. INSTALL COURTESY LIGHT ASSEMBLY

9. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

10. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

11. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

13. INITIALIZE POWER WINDOW CONTROL SYSTEM

(See page )

14. INSPECT SRS WARNING LIGHT

(See page )

Inspection

INSPECTION PROCEDURE 1. INSPECT FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (a) Apply positive (+) battery voltage to connector terminal 2 (B). NOTICE: Do not apply positive (+) ...

Power Window Regulator Motor(for Rear Door)

...

Other materials about Toyota Venza:

Certification Ecu
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. N ...

Door Courtesy Switch Circuit
DESCRIPTION The main body ECU (driver side junction block assembly) detects the condition of the door courtesy light switch. WIRING DIAGRAM PROCEDURE 1. READ VALUE USING TECHSTREAM (a) Connect the Techstream to the DLC3 ...

Door Courtesy Switch Circuit
DESCRIPTION When an additional transponder key is registered, the transponder key ECU assembly detects the front door courtesy light switch assembly (for driver side) open/close condition, and enters the key registration mode. WIRING DIAGRAM CAUTION / ...