Toyota Venza: Intuitive Parking Assist System

Clearance Warning Ecu

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE FRONT DOOR SCUFF PLATE RH 2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH 3. REMOVE NO. 2 INSTRUMENT PANEL UNDER COV ...

Precaution

PRECAUTION 1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) aft ...

Other materials about Toyota Venza:

Precaution
PRECAUTION 1. TROUBLESHOOTING PRECAUTION NOTICE: Be sure to read the supplemental restraint system precautions thoroughly before servicing the brake system (See page ). Care must be taken to replace each part properly as it could affect ...

Rear Left Center Sensor Malfunction (C1AE7)
DESCRIPTION The No. 1 ultrasonic sensor (rear left center sensor) is installed on the rear bumper. The ECU detects obstacles based on signals received from the No. 1 ultrasonic sensor (rear left center sensor). If the No. 1 ultrasonic sensor (rear left ce ...

Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0141,P102D)
DESCRIPTION Refer to DTC P0136 (See page ). HINT: When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is t ...