Toyota Venza: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Intuitive Parking Assist System|
DTC Code |
Detection Item |
See page |
|---|---|---|
|
C1AE1 |
Front Left Sensor Malfunction |
|
|
C1AE4 |
Front Right Sensor Malfunction |
|
|
C1AE6 |
Rear Left Sensor Malfunction |
|
|
C1AE7 |
Rear Left Center Sensor Malfunction |
|
|
C1AE8 |
Rear Right Center Sensor Malfunction |
|
|
C1AE9 |
Rear Right Sensor Malfunction |
|
|
C1AEC |
Front Sensor Communication Malfunction |
|
|
C1AED |
Rear Sensor Communication Malfunction |
|
|
U0100 |
Lost Communication with ECM / PCM "A" |
|
|
U0101 |
Lost Communication with TCM |
|
|
U0142 |
Lost Communication with Body Control Module "B" |
|
|
U0155 |
Lost Communication with Instrument Panel Cluster Control Module (Combination Meter) |
|
.gif)
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the clearance sonar main switch on.
(d) Turn the Techstream on.
(e) Enter the ...
Lost Communication with ECM / PCM "A" (U0100-U0142,U0155)
DESCRIPTION
These DTCs are stored when the clearance warning ECU assembly cannot receive
and recognize several signals via the CAN communication system.
DTC No.
DTC Detection ...
Other materials about Toyota Venza:
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL COOLER DRYER
(a) Using pliers, install a new cooler dryer to the modulator.
(b) Apply sufficient compressor oil to the O-ring and fitting surfaces
of t ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
PROCEDURE
1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
3. REMOVE REAR DISC ...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
(a) Disconnect the D25 certification ECU (smart key ECU assembly) connector.
(b) Measure the voltage and resistance according to the value(s) in the table
below.
HINT:
Measure the va ...
0.1149