Toyota Venza: Tire Pressure Monitoring
- Tire Pressure Warning Ecu
- Tire Pressure Warning Receiver
- Tire Pressure Warning System
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- System Description
- Registration
- Problem Symptoms Table
- Test Mode Procedure
- Diagnosis System
- Terminals Of Ecu
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Vehicle Speed or Engine Speed Signal Malfunction (C2173/73)
- Receiver Error (C2176/76)
- Transmitter ID not Registered (C2171/71)
- Transmitter ID not Received in Main Mode (C2126/26)
- Engine Speed Signal Error (Test Mode DTC) (C2194/94)
- No Signal from Transmitter ID1 (C2121/21-C2124/24,C2181/81-C2184/84)
- Abnormal Temperature Inside ID1 Tire (C2165/65-C2168/68)
- Transmitter ID1 Error (C2141/41-C2144/44)
- Vehicle Speed Signal Error (Test Mode DTC) (C2191/91)
- Transmitter ID1 Operation Stop (C2111/11-C2114/14)
- ECU Power Source Circuit
- Tire Pressure Warning Light Circuit
- TC and CG Terminal Circuit
- Tire Pressure Warning Valve
Inspection
INSPECTION
PROCEDURE
1. INSPECT TIRES
(a) Inspect the tires for wear and proper inflation pressure.
Cold Tire Inflation Pressure:
Tire Size
Front
kPa (kgf/cm2, psi)
...
Tire Pressure Warning Ecu
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Removal
REMOVAL
CAUTION / NOTICE / HINT
NOTICE:
Before removing the tire pressure warning ECU, read the registered transmitter
IDs of ...
Other materials about Toyota Venza:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" ...
Open in One Side of CAN Branch Line
DESCRIPTION
If some ECUs and sensors are not displayed on the "CAN Bus Check" screen of the
Techstream and some ECUs and sensors repeatedly appear and disappear from the screen
when the CAN main bus wires are normal (there is no open, short, sho ...
Selecting the units
Press the “US/M-M” button.
The unit changes each time the button is pressed.
- Liquid crystal display
Small spots or light spots may appear on the display. This phenomenon is characteristic
of liquid crystal displays, and there is no problem to ...
0.1478