Toyota Venza: Receiver Error (C2176/76)

Toyota Venza Service Manual / Tire Pressure Monitoring / Tire Pressure Warning System / Receiver Error (C2176/76)

DESCRIPTION

The signals are transmitted to the tire pressure warning antenna and receiver on the body as radio waves and then sent to the tire pressure warning ECU.

DTC No.	DTC Detection Condition	Trouble Area
C2176/76	Malfunction in the tire pressure warning ECU internal circuit	Tire pressure warning ECU

CAUTION / NOTICE / HINT

NOTICE:

When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
It is necessary to perform registration (See page ) of the transmitter IDs into the tire
pressure warning ECU if the ECU has been replaced.

PROCEDURE

1.	CHECK DTC OUTPUT (C2176/76)

(a) Clear the DTC (See page ).

(b) Turn the ignition switch off.

OK:

DTC C2176/76 is not output.

END

REPLACE TIRE PRESSURE WARNING ECU

Vehicle Speed or Engine Speed Signal Malfunction (C2173/73)

DESCRIPTION The tire pressure warning ECU receives a vehicle speed signal from the combination meter and an engine speed signal from the ECM. The tire pressure warning ECU uses these signals to d ...

Transmitter ID not Registered (C2171/71)

DESCRIPTION Each tire pressure warning valve and transmitter ID is registered to the tire pressure warning ECU. When the ECU detects a transmitter ID code not registered in the ECU, a DTC is out ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater Syste ...

System Diagram
SYSTEM DIAGRAM Communication Table Transmitting ECU Receiving ECU Signal Communication Method Air Conditioning Control Assembly Air Conditioning Amplifier Assembly Rear windo ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FUEL PUMP ASSEMBLY WITH FILTER HINT: Perform "Inspection After Repair" after replacing the fuel pump (See page ). (a) Apply gasoline to a new O-ring. Then install the O-ring and spacer to the fuel ...