Toyota Venza manuals

Toyota Venza: 1ar-fe Battery / Charging

Toyota Venza Service Manual / 1ar-fe Battery / Charging

TC and CG Terminal Circuit
DESCRIPTION Connecting terminals TC and CG of the DLC3 causes the system to enter self-diagnostic mode. If a malfunction is present, the MIL will blink. HINT: When a particular warning light rema ...

Charging System
...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. REMOVE COOL AIR INTAKE DUCT SEAL 3. REMOVE NO. 1 ENGINE CO ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. DTC CHECK (USING SST CHECK WIRE) (a) Turn the ignition switch off. (b) Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3. SST: 09843-18040 (c) Turn the ignition switch to ON. (d) Read and record any DTCs from the tire pre ...

Under Hood
General Maintenance GENERAL MAINTENANCE PROCEDURE 1. GENERAL NOTES Maintenance requirements vary depending on the country. Check the maintenance schedule in the owner's manual supplement. Following the maintenance schedule is mandat ...

© 2016-2026 Copyright www.tovenza.com

0.1403