Toyota Venza manuals

Toyota Venza: Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

  • Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  • Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Charging System

Symptom

Suspected Area

See page

Charge Warning Light Comes ON while Driving

Clutch pulley


Generator assembly


Noise Occurs from Generator while Engine is Running

V-ribbed belt


Clutch pulley


Generator assembly


On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. CHECK BATTERY CONDITION NOTICE: If the battery is weak or if the engine is difficult to start, perform the following procedure. (a) Check the battery for dama ...

Charge Warning Light Comes ON while Driving
PROCEDURE 1. CHECK LOCK FUNCTION OF CLUTCH PULLEY (a) Check the lock function with the pulley installed in the vehicle. (1) Visually check that the rotor in the gene ...

Other materials about Toyota Venza:

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR AXLE CARRIER SUB-ASSEMBLY (a) Temporarily install the rea ...

Fail-safe Chart
FAIL-SAFE CHART 1. FAIL SAFE FUNCTION (a) The following chart shows the status of the controls when the system is normal and malfunctioning. The passenger airbag ON/OFF indicator ("ON" and "OFF") comes on for approximately 4 ...

Installation
INSTALLATION PROCEDURE 1. INSTALL FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY (a) Engage the 8 clamps. (b) Engage the 2 claws and connect the fuel lid lock control cable sub-assembly. 2. INSTALL FUE ...

© 2016-2026 Copyright www.tovenza.com

0.1513