Toyota Venza manuals

Toyota Venza: Charging System

1ar-fe Battery / Charging
...

Precaution
PRECAUTION 1. Check that the battery cables are connected to the correct terminals. 2. Disconnect the battery cables when the battery is given a quick charge. 3. Do not perform tests with a high vo ...

Other materials about Toyota Venza:

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT SPEEDOMETER (a) Check the operation. (1) Using a speedometer tester (calibrated chassis dynamometer), check the speedometer indication according to the table below. Reference: Chassis Dynamometer In ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Back Door / DTC. HINT: Refer to the Techstream operator's manual ...

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. REMOVE COOL AIR INTAKE DUCT SEAL 3. REMOVE NO. 1 ENGINE CO ...

© 2016-2026 Copyright www.tovenza.com

0.1603