Toyota Venza: Air Conditioning System
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Customize Parameters
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Actuator Check
- Lost Communication with ECM (U0100-U0142,U0155)
- Front Passenger Side Solar Sensor Short Circuit (B14A3)
- Driver Side Solar Sensor Short Circuit (B14A2)
- Compressor Solenoid Circuit (B1451/51)
- BUS IC Communication Malfunction (B1497/97)
- Air Mix Damper Control Servo Motor Circuit (Driver Side) (B1446/46)
- Air Inlet Damper Control Servo Motor Circuit (B1442/42)
- Air Outlet Damper Control Servo Motor Circuit (B1443/43)
- Air Mix Damper Control Servo Motor Circuit (Passenger Side) (B1441/41)
- Pressure Sensor Circuit (B1423/23)
- Evaporator Temperature Sensor Circuit (B1413/13)
- Compressor Lock Sensor Circuit (B1422/22)
- Room Temperature Sensor Circuit (B1411/11)
- Ambient Temperature Sensor Circuit (B1412/12)
- Air Conditioning Control Panel Circuit
- Air Conditioning Compressor Magnetic Clutch Circuit
- Blower Motor Circuit
- IG Power Source Circuit
- Back-up Power Source Circuit
Air Conditioning Pressure Sensor
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL AIR CONDITIONING PRESSURE SENSOR
(a) Sufficiently apply compressor oil to a new air conditioni ...
Precaution
PRECAUTION
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following systems after the cable is reconnected.
System Name
See Proc ...
Other materials about Toyota Venza:
Short in GPS Antenna (B15C0,B15C1)
DESCRIPTION
These DTCs are stored when a malfunction occurs in the navigation antenna assembly.
DTC No.
DTC Detection Condition
Trouble Area
B15C0
Navigation antenna malfunction
...
Removal
REMOVAL
PROCEDURE
1. REMOVE NO. 1 FLOOR UNDER COVER
(a) Disengage the 4 nuts and clip, and remove the No. 1 floor under cover.
Text in Illustration
Nut (attached to under cover)
HINT:
Rotate the clip to disengage it. The 4 ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL THROTTLE BODY ASSEMBLY
(a) Install a new gasket to the intake manifold.
(b) Install the fuel tube bracket with the bolt.
Torque:
7.5 N·m {76 kgf ...
0.1288