Toyota Venza: Theft Deterrent System(w/ Smart Key System)
- Parts Location
- Precaution
- System Diagram
- How To Proceed With Troubleshooting
- System Description
- Customize Parameters
- Problem Symptoms Table
- Terminals Of Ecu
- Data List / Active Test
- Diagnosis System
- Engine Hood Courtesy Switch Circuit
- Horn Circuit
- Security Horn Circuit
- Security Indicator Light Circuit
- ECU Power Source Circuit
Power Source Mode does not Change to ON (ACC)
DESCRIPTION
When the engine switch is pushed with the electrical key in the cabin, the power
management control ECU receives signals to change the power source mode.
HINT:
To allow use of the Tec ...
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...
Other materials about Toyota Venza:
Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
If installing a new rear differential carrier assembly, remove the 2 differential
side seal caps before installing the rear drive shaft assembly.
PROCEDURE
1. INSTALL REAR DIFFERENTIAL DYNAMIC DAMPER
HINT:
...
Lost Communication with Power Source Control (B278C)
DESCRIPTION
This DTC is stored when LIN communication between the certification ECU (smart
key ECU assembly) and power management control ECU stops for more than 10 seconds.
DTC Code
DTC Detection Condition
Trouble Area
...
Camshaft Position Sensor Circuit Malfunction (P0340,P0342,P0343)
DESCRIPTION
The camshaft position sensor (G signal sensor) for the intake camshaft consists
of a magnet and MRE (Magneto Resistance Element).
The camshaft has a timing rotor for the camshaft position sensor. When the camshaft
rotates, changes occur in th ...
0.1392