Toyota Venza: Customize Parameters

Toyota Venza Service Manual / Theft Deterrent / Keyless Entry / Theft Deterrent System(w/ Smart Key System) / Customize Parameters

CUSTOMIZE PARAMETERS

HINT:

The following items can be customized.

NOTICE:

After confirming whether the items requested by the customer are applicable or not for customization, perform customizing operations.
Be sure to record the current settings before customization.
When troubleshooting, make sure that the item in question is not set to OFF as a result of customization (Example: For the system, "the wireless function does not operate", first check that the wireless function is not set to OFF, then perform troubleshooting).

1. CUSTOMIZE

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(d) Enter the following menus: Customize Setting /

(e) Select the setting by referring to the table below.

Security

Display (Item)	Default	Content	Setting
Warning by Horn	ON	Function that allows the vehicle horn and theft deterrent horn to be used as warning devices.	ON or OFF
Passive Mode (Security System)	OFF	Passive Mode is a function that switches the theft deterrent system from the arming preparation state to the armed state 30 seconds after the key is removed from the actuation area and all doors, engine hood and back door are closed, even if the doors are not locked by wireless or door key lock operation. In Passive Mode, if the following operations are not performed within 14 seconds after a door is opened during armed state, the theft deterrent system will judge that condition as a theft and switch to the alarm sounding state. Unlock any door by key or wireless operation Turn the engine switch on (IG)	ON or OFF
Entry Delay	14 s	Function that changes entry delay time (time before warning starts) for Passive Mode	0 s, 14 s or 30 s

System Description

SYSTEM DESCRIPTION 1. OUTLINE OF THEFT DETERRENT SYSTEM The theft deterrent system can be set by locking the doors using the transmitter or key, or by opening and closing the doors (for d ...

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL POWER OUTLET SOCKET COVER NO.1 (a) Engage the 2 claws to install the power point socket cover. 2. INSTALL POWER POINT SOCKET ASSEMBLY (a) Engage the 2 c ...

Air Conditioning Compressor Magnetic Clutch Circuit
DESCRIPTION When the A/C amplifier is turned on, a magnetic clutch ON signal is sent from the MGC terminal of the A/C amplifier. Then, the MGC relay turns on to operate the magnetic clutch. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the ...

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater Syste ...