Toyota Venza: When driving
Driving, stopping and safe-driving information
- Driving procedures
- Driving the vehicle
- Engine (ignition) switch (vehicles with smart key system)
- Engine (ignition) switch (vehicles without smart key system)
- Automatic transmission
- Turn signal lever
- Parking brake
- Horn
- Instrument cluster
- Gauges and meters
- Indicators and warning lights
- Multi-information display (TFT type)
- Multi-information display (LCD type)
- Operating the lights and wipers
- Using other driving systems
- Driving information
Child restraint systems with a top tether strap
Secure the child restraint using
a seat belt or lower anchors, and do the following.
► Outside
Adjust the head restraint to the upmost position.
► Center
Lower the head restrain ...
Other materials about Toyota Venza:
TC and CG Terminal Circuit
DESCRIPTION
Connecting terminals TC and CG of the DLC3 causes the system to enter self-diagnostic
mode. If a malfunction is present, the MIL will blink.
HINT:
When a particular warning light remains blinking, a ground short in the wiring
of terminal TC ...
Washer Motor(for Front Side)
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT WHEEL RH
2. REMOVE FRONT FENDER OUTSIDE MOULDING RH
HINT:
Use the same procedure for the RH side and LH side (See page
).
3. REMOVE FRONT FENDER LINER RH
...
Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR DRIVE SHAFT ASSEMBLY
(a) Check whether the drive shaft dimensions are within the following
specifications.
HINT:
The following table shows the dimension (A) of the drive shaft.
Dimension (A)
...
0.1589