Toyota Venza: Rear window wiper and washer
Type A
1. 
Off
2. 
Intermittent window wiper operation
3. 
Normal window wiper operation
4. 
Washer/wiper dual operation
5. 
Washer/wiper dual operation
Type B
1. 
Off
2. 
Intermittent window wiper operation
3. 
Normal window wiper operation
4. 
Washer/wiper dual operation
5. 
Washer/wiper dual operation
- The rear window wiper and washer can be operated when
► Vehicles with smart key system The “ENGINE START STOP” switch is in IGNITION ON mode.
► Vehicles without smart key system The engine switch is in the “ON” position.
NOTICE
- When the rear window is dry
Do not use the wipers, as they may damage the rear window.
Fog light switch
The fog lights improve visibility in difficult driving conditions, such as
in rain or fog. The fog lights can be used when the headlights are on low beam.
Type A
1. Off
2. On
Type B
1. O ...
Other materials about Toyota Venza:
Transmitter ID1 Operation Stop (C2111/11-C2114/14)
DESCRIPTION
The tire pressure warning valve and transmitter installed in each tire and wheel
assembly measures the tire pressures. The measured values are transmitted as radio
waves to the tire pressure warning antenna and receiver on the body and then se ...
Checking Monitor Status
CHECKING MONITOR STATUS
The purpose of the monitor result (mode 06) is to allow access to the results
of on-board diagnostic monitoring tests of specific components/systems that are
not continuously monitored. Examples are catalysts and evaporative emissi ...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
ACTIVE TORQUE CONTROL 4WD SYSTEM
DTC Code
Detection Item
Trouble Area
See page
C1241/94
Low Power Supply Voltage
1. Battery
2. ECU-IG1 fuse
...
0.1452