Toyota Venza: Driving procedures

When driving

Driving, stopping and safe-driving information ...

Driving the vehicle

The following procedures should be observed to ensure safe driving.  - Starting the engine  - Driving With the brake pedal depressed, shift the shift lever to “D”. Release the pa ...

Other materials about Toyota Venza:

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT BRAKE BOOSTER ASSEMBLY (a) Airtightness check (1) Start the engine and stop it after 1 or 2 minutes. Slowly depress the brake pedal several times. HINT: If the pedal can be depressed to the ...

Low Power Supply Voltage (C1241/94)
DESCRIPTION If a malfunction in the power source circuit occurs, or a malfunction in communication with the skid control ECU or in a speed sensor occurs, the AWD control ECU will prohibit operations by the fail-safe function. DTC No. ...

Oxygen (A/F) Sensor Heater Control Circuit Low (Bank 1 Sensor 1) (P0031,P0032,P101D)
DESCRIPTION Refer to DTC P2195 (See page ). HINT: When any of these DTCs is stored, the ECM enters fail-safe mode. The ECM turns off the air fuel ratio sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is t ...