Toyota Venza: Power Outlets (int)

Installation

INSTALLATION PROCEDURE 1. INSTALL INNER REAR VIEW MIRROR ASSEMBLY (w/o Automatic High Beam System) (a) Using a T20 "TORX" socket wrench, install the inner rear view mirror assembly with ...

Center Power Outlet Socket

Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL CENTER POWER OUTLET SOCKET COVER (a) Engage the 2 claws to install the center power outlet soc ...

Other materials about Toyota Venza:

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL COOLER DRYER (a) Using pliers, install a new cooler dryer to the modulator. (b) Apply sufficient compressor oil to the O-ring and fitting surfaces of t ...

Test Mode Procedure
TEST MODE PROCEDURE 1. ENTER TEST MODE (SIGNAL CHECK MODE) (a) Turn the ignition switch off. (b) Connect the Techstream to the DLC3. (c) Turn the ignition switch to ON. (d) Check that the tire pressure warning light comes on for 3 seconds and then goes ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the tab ...