Toyota Venza: Rear Power Outlet Socket

Installation

INSTALLATION PROCEDURE 1. INSTALL POWER OUTLET SOCKET COVER NO.1 (a) Engage the 2 claws to install the power point socket cover. 2. INSTAL ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Slip Indicator Light does not Come ON
DESCRIPTION The skid control ECU is connected to the combination meter via CAN communication. WIRING DIAGRAM Refer to Slip Indicator Light Remains ON (See page ). PROCEDURE 1. CHECK CAN COMMUNICATION SYSTEM (a) Check if ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE FUEL SENDER GAUGE 2. SEPARATE FUEL SUCTION PLATE SUB-ASSEMBLY (a) Disconnect the fuel pump connector from the fuel suction plate. NOTICE: Do not damage the wire harness. ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" ...