Toyota Venza: Power Outlet Socket

Center Power Outlet Socket

Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL CENTER POWER OUTLET SOCKET COVER (a) Engage the 2 claws to install the center power outlet soc ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Pressure Sensor Circuit (B1423/23)
DESCRIPTION This DTC is output when refrigerant pressure on the high pressure side is extremely low (190 kPa (1.9 kgf/cm2, 28 psi) or less) or extremely high (3140 kPa (32.0 kgf/cm2, 455 psi) or more). The A/C pressure sensor is installed on the high pres ...

Removal
REMOVAL PROCEDURE 1. REMOVE FRONT WHEEL LH 2. REMOVE FRONT FENDER OUTSIDE MOULDING LH 3. REMOVE FRONT FENDER LINER LH (a) Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips. Text in Illustration ...

Engine Speed Signal Error (Test Mode DTC) (C2194/94)
DESCRIPTION The tire pressure warning ECU receives an engine speed signal from the ECM. This DTC is stored upon entering signal check mode (test mode), and cleared when an engine speed signal of 1000 rpm is detected for 3 seconds or more. This DTC is outp ...