Toyota Venza: Removal

Toyota Venza Service Manual / Window / Glass / Rear Power Window Switch / Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

2. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY

(a) Disengage the 2 claws and remove the power window regulator switch assembly.

Inspection

INSPECTION PROCEDURE 1. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (for Rear LH) (a) Check the switch function. (1) Measure the resistance according to the value(s) in the table b ...

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL POWER WINDOW R ...

Other materials about Toyota Venza:

Communication Malfunction No. 1 (B2797)
DESCRIPTION This DTC is stored when an error occurs in communication between the transponder key amplifier and the transponder key ECU assembly. HINT: Some noise is found in the communication line. DTC No. DTC Detection Condition ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE STEERING RACK BOOT CLIP (for LH Side) (a) Using pliers, remove the steering rack boot clip. 2. REMOVE STEERING RACK BOOT CLIP (for RH Side) HINT: Perform the same procedure as for the LH side. 3. REMOVE NO. 2 STEERING RAC ...

Fail-safe Chart
FAIL-SAFE CHART 1. FAIL-SAFE FUNCTION (a) When communication fails in any of the CAN bus wires (communication wires), a fail-safe function(s) will operate. The fail-safe function that is specified for each system operates to prevent those systems from ma ...