Toyota Venza: Smart Key System(for Entry Function)
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Problem Symptoms Table
- Diagnosis System
- Terminals Of Ecu
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Open in Outside Luggage Compartment Electrical Key Antenna Circuit (B27A8)
- Open in Rear Floor Electrical Key Oscillator Circuit (B27A6)
- Open in Inside Luggage Compartment Electrical Key Oscillator Circuit (B27A7)
- Open in Front Floor Electrical Key Oscillator Circuit (B27A5)
- Open in Driver Side Electrical Antenna Circuit (B27A1)
- Open in Front Passenger Side Electrical Antenna Circuit (B27A2)
- Entry Answer-back Buzzer does not Sound
- All Door Entry Lock/Unlock Functions and Wireless Functions do not Operate
- All Door Entry Lock/Unlock Functions do not Operate, but Wireless Functions Operate
- Driver Side Door Entry Unlock Function does not Operate
- Driver Side Door Entry Lock and Unlock Functions do not Operate
- Front Passenger Side Door Entry Unlock Function does not Operate
- Front Passenger Side Door Entry Lock and Unlock Functions do not Operate
- Driver Side Door Entry Lock Function does not Operate
- Front Passenger Side Door Entry Lock Function does not Operate
- Room Oscillator does not Recognize Key
- Entry Interior Alarm does not Sound
- Back Door Entry Unlock Function does not Operate
- Back Door Entry Lock and Unlock Functions do not Operate
- Back Door Entry Lock Function does not Operate
Security Horn Assembly
Removal
REMOVAL
PROCEDURE
1. REMOVE SECURITY HORN ASSEMBLY
(a) Remove the bolt and disconnect the security horn assembly.
(b ...
Precaution
PRECAUTION
1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following system after ...
Other materials about Toyota Venza:
Driver Side Power Mirror cannot be Adjusted with Power Mirror Switch
SYSTEM DESCRIPTION
When the mirror adjust switch is operated, the main body ECU (driver side junction
block assembly) detects the switch operation and sends the mirror adjust switch
signal to the outer mirror control ECU assembly (driver door) via CAN com ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
When disconnecting the steering intermediate shaft assembly and pinion shaft
of steering gear assembly, be sure to place matchmarks before servicing.
PROCEDURE
1. INSTALL TIE ROD ASSEMBLY LH
(a) I ...
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems ne ...
0.1386