Toyota Venza: Rear Seat Assembly(for Rh Side)

Installation

INSTALLATION PROCEDURE 1. INSTALL REAR SEAT ASSEMBLY LH (a) Place the rear seat assembly LH in the cabin. NOTICE: Be careful not to damage the vehicle body. (b) Temporarily install th ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. REMOVE FRONT DOOR SCUFF PLATE LH 2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH 3. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL 4. REMOVE LOWER STEERING COLUMN COVER (a) Turn the steering wheel assembly to the right ...

Precaution
PRECAUTION 1. PRECAUTION FOR DISCONNECTING THE BATTERY CABLE NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected: System See Procedure ...

Short in Curtain Shield Squib RH Circuit (B1830/57-B1833/57)
DESCRIPTION The curtain shield squib RH circuit consists of the center airbag sensor assembly and curtain shield airbag assembly RH. The center airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These DTCs ...