Toyota Venza: Rear Bumper

Radiator Grille

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE COOL AIR INTAKE DUCT SEAL 2. REMOVE RADIATOR GRILLE (a) Put protective tape around the radiator grill ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Pressure Sensor Circuit (B1423/23)
DESCRIPTION This DTC is output when refrigerant pressure on the high pressure side is extremely low (190 kPa (1.9 kgf/cm2, 28 psi) or less) or extremely high (3140 kPa (32.0 kgf/cm2, 455 psi) or more). The A/C pressure sensor is installed on the high pres ...

Headlight Leveling ECU Power Source Circuit
DESCRIPTION This circuit detects the state of the ignition switch, and sends it to the headlight leveling ECU assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the followin ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FRONT SEAT WIRE RH (for Front Passenger Side) (a) Engage each clamp and install the front seat wire RH. 2. INSTALL OCCUPANT CLASSIFICATION ECU (for Front Passenger Side) 3. INSTALL SEAT POSITION SENSOR 4. INSTALL SEA ...