Toyota Venza: Transponder Chip Malfunction (B2793)
DESCRIPTION
This DTC is stored when a malfunction is found in the key during key code registration or a key code is not registered normally. Replace the key if the key code registration is not performed normally and this DTC is detected.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
B2793 |
Transponder chip malfunction. |
Key |
CAUTION / NOTICE / HINT
NOTICE:
If the key is replaced, register the key (See page
.gif)
).
PROCEDURE
|
1. |
CLEAR DTC |
(a) Clear the DTCs (See page ).
|
.gif)
|
2. |
RE-REGISTER KEY |
(a) Re-register the key (See page ).
|
|
3. |
CHECK ENGINE START |
(a) Check that the engine starts.
OK:
The engine starts.
| OK | .gif) |
END (KEY WAS NOT REGISTERED CORRECTLY) |
| NG | |
REPLACE KEY |
Antenna Coil Open / Short (B2784)
DESCRIPTION
The transponder key coil is built into the transponder key amplifier and receives
a key code signal from the transponder chip in the key. This signal is amplified
by the amplifier, th ...
Unmatched Key Code (B2795)
DESCRIPTION
This DTC is stored when a key with a key code that has not been registered in
the ECU is inserted into the ignition key cylinder.
DTC No.
DTC Detection Condition
...
Other materials about Toyota Venza:
Registered Device cannot be Deleted
PROCEDURE
1.
DELETE OPERATION
(a) Check if a registered portable player can be deleted normally.
OK:
Registered portable player can be deleted normally.
OK
END
NG
PROCEED TO ...
Fail-safe Chart
FAIL-SAFE CHART
If a problem occurs in the power steering system, the power steering assist will
be stopped or the amount of power assist will be decreased to protect the system.
Power Steering System
Malfunction
Fail-safe Operation
...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
If a trouble code is displayed during the DTC check, check the circuit listed
for the code in the table below (refer to the appropriate page).
HINT:
When the SRS warning light remains on and the DTC output is the norm ...
0.1595