Toyota Venza: Power Back Door Drive Unit

Power Back Door Control Switch

Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT POWER BACK DOOR OPENER / CLOSER SWITCH (a) Measure the resistance of the switch. Standard resistance: ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION (a) When troubleshooting On-Board Diagnostic (OBD II) vehicles, the vehicle must be connected to the OBD II scan tool (complying with SAE J1987). Various data output from the vehicle TCM can then be read. (b) OBD II regul ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 1 CENTER SUPPORT BEARING ASSEMBLY (a) Set the No. 1 center support bearing on the intermediate shaft as shown in the illustration. NOTICE: Make sure to install the bearing in the correct position. ...

System Too Lean (Bank 1) (P0171,P0172)
DESCRIPTION The fuel trim is related to the feedback compensation value, not to the basic injection duration. The fuel trim consists of both the short-term and long-term fuel trims. The short-term fuel trim is fuel compensation that is used to constantly ...