Toyota Venza: Oil Pump

Differential Oil Seal

Components COMPONENTS ILLUSTRATION Replacement REPLACEMENT PROCEDURE 1. DRAIN AUTOMATIC TRANSAXLE FLUID (a) Remove the No. 2 engine under cover and front fender apron LH. (b) ...

Components

COMPONENTS ILLUSTRATION ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. NOTICE: When disconnecting the cable, some systems ne ...

ECU Power Source Circuit
DESCRIPTION When the ignition switch is turned to ON, voltage from the ECM's MREL terminal is applied to the EFI MAIN relay. This causes the contacts of the EFI MAIN relay to close, which supplies power to terminal +B of the TCM. WIRING DIAGRAM PR ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE REAR WHEEL 2. SEPARATE REAR SPEED SENSOR 3. REMOVE REAR AXLE SHAFT NUT ...