INSPECTION
PROCEDURE
1. INSPECT FRONT SEAT FRAME WITH ADJUSTER LH
(a) Check operation of the seat frame (slide motor).
(1) w/ Memory: Check if the seat frame moves smoothly when the battery is connected to the slide motor connector terminals. OK:
If the result is not as specified, replace the front seat frame with adjuster LH. |
|
(2) w/o Memory: Check if the seat frame moves smoothly when the battery is connected to the slide motor connector terminals. OK:
If the result is not as specified, replace the front seat frame with adjuster LH. |
|
(b) Check operation of the seat frame (front vertical motor). (1) Check if the seat frame moves smoothly when the battery is connected to the front vertical motor connector terminals. OK:
If the result is not as specified, replace the front seat frame with adjuster LH. |
|
(c) Check operation of the seat frame (reclining motor). (1) Check if the seat frame moves smoothly when the battery is connected to the reclining motor connector terminals. OK:
If the result is not as specified, replace the front seat frame with adjuster LH. |
|
(d) Check operation of the seat frame (lifter motor). (1) Check if the seat frame moves smoothly when the battery is connected to the lifter motor connector terminals. OK:
If the result is not as specified, replace the front seat frame with adjuster LH. |
|
2. INSPECT FRONT SEAT FRAME WITH ADJUSTER RH
(a) Check operation of the seat frame (slide motor). (1) Check if the seat frame moves smoothly when the battery is connected to the slide motor connector terminals. OK:
If the result is not as specified, replace the front seat frame with adjuster RH. |
|
(b) Check operation of the seat frame (reclining motor). (1) Check if the seat frame moves smoothly when the battery is connected to the reclining motor connector terminals. OK:
If the result is not as specified, replace the front seat frame with adjuster RH. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL ENGINE SWITCH
(a) Attach the 2 claws to install the engine switch.
2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
(a) Connect the connector.
...
Dtc Check / Clear
DTC CHECK / CLEAR
1. DTC CHECK (USING SST CHECK WIRE)
(a) Check the DTCs (Current trouble codes).
(1) Turn the ignition switch to ON, and wait for approximately 60 seconds.
(2) Using SST, connect terminals TC and CG of the DLC3.
SST: 09843-18040
NOTICE ...
CD cannot be Inserted or is Ejected Right After Insertion
PROCEDURE
1.
CHECK IF A PROPER CD IS INSERTED
(a) Make sure that the CD is an audio CD or a CD with an MP3, WMA or AAC files,
and that it is not deformed, flawed, stained, deteriorated or otherwise defective.
OK:
Normal C ...