Toyota Venza: Front Seatback Heater

Inspection

INSPECTION PROCEDURE 1. INSPECT FRONT SEAT FRAME WITH ADJUSTER LH (a) Check operation of the seat frame (slide motor). (1) w/ Memory: Check if the seat frame moves smoothly when the ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. REMOVE REAR WHEELS 2. REMOVE CENTER EXHAUST PIPE ASSEMBLY (a) Remove the center exhaust pipe assembly. HINT: Refer to the instructions for Removal of the exhaust pipe (See page for 2GR-FE, for 1AR-FE). 3. REMOVE LOWER NO. 1 EXH ...

Installation
INSTALLATION PROCEDURE 1. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY 2. INSTALL NO. 2 RADIO RECEIVER BRACKET (a) Install the No. 2 radio receiver bracket with the 4 screws. Torque: 5.0 N·m {51 kgf·cm, 44 in·lbf} 3. INSTALL NO. 1 RADIO RECEIVER BRAC ...

Removal
REMOVAL PROCEDURE 1. REMOVE NO. 1 SLIDING ROOF GLASS SUB-ASSEMBLY (a) Fully open the No. 2 sliding roof glass sub-assembly. (b) Using a T20 "TORX" socket wrench, remove the 6 screws and No. 1 sliding roof glass sub-assembly. ...